Sensor (Fuser Exit) Static Jam; Sensor (Exit 2) On Jam - Lexmark X850e Service Manual

202.02 Sensor (fuser exit) static jam

Step
1 Check the media position.
Open the printer left door assembly and visually check it.
Does the media touch the sensor (fuser exit).
Open the printer left door assembly and visually check it.?
2 Check the sensor (fuser exit) for operation.
1. Enter the Diagnostics Menu.
2. Touch BASE SENSOR TEST.
3. Touch Media Path.
4. Touch Fuser exit.
Open the printer left door assembly and check it.
Caution: The area around the actuator is very hot. Allow
the fuser area to cool before proceeding.
Does the display, on the operator panel, change every time
the sensor actuator is operated?
3 Is the sensor (fuser exit) properly connected?
4 Perform a print test.
Does the error continue?

203.00 Sensor (exit 2) on jam

Step
1 Check the media position.
Open the printer left door assembly, and visually check
it.
Does the media touch the sensor (fuser exit)?
2 Check the media position.
Open the exit 2 left door assembly, and visually check it.
Does the media touch the sensor (exit 2)?
3 Check the roll.
Open printer left door assembly.
Is the exit 1 media exit roll assembly free of excess wear
and contamination?
Check
Check
Yes
Remove the Go to step 2.
media.
Go to step 4. Go to step 3.
Replace the Replace the
sensor (fuser exit). connection.
Go to "Sensor
(fuser exit)
removal" on
page 4-103.
Replace the Problem solved.
printer engine card
assembly.
Go to "Printer
engine card
assembly
removal" on
page 4-117.
Yes
Remove the media. Go to step 2.
Remove the media. Go to step 3.
Go to step 4. Clean or replace the
exit 1 media shift
assembly.
Go to
shift assembly
removal" on
page 4-105
Diagnostic information
7500-XXX
No
No
"Exit 1 media
2-45