Tray 2 Media Size Mismatch In Length - Lexmark X850e Service Manual

7500-XXX
Step
13 Perform a print test.
Does the error continue?

Tray 2 media size mismatch in length

Step
1 Check the media.
Pull out tray 2 to visually check it.
Is media loaded in tray 2 properly?
2 Check the media.
Pull out tray 2 to visually check it.
Are the front media tray guide assembly, rear media tray
guide, and media tray end guide of tray 2 set correctly?
3 Check the switch (media size) for tray 2 installation.
Is the switch (media size) for tray 2 installed correctly?
Pull out tray 2 to visually check it.
4 Check the switch (media size) for tray 2 connection.
Is the switch (media size) for tray 2 properly connected?
5 Check the roll for tray 2.
Pull out tray 2 and check it.
Is the feed roll, separation roll, and pick roll free of excess
wear and contamination?
6 Open the printer left door assembly and visually check it.
Check the media position.
Does the media touch the sensor (registration)?
2-200
MFP Service Manual
Check
Check
Yes
Replace the Problem solved.
printer engine card
assembly.
Go to "Printer
engine card
assembly
removal" on
page 4-117.
Yes
Go to step 2. Load media
properly.
Go to step 3. Set the guides
properly.
Go to step 4. Install the switch
(media size) for
tray 2 correctly.
Go to
(media size)
removal" on
page
Replace the switch Replace the
(media size). connection.
"Switch (media
size) removal" on
page 4-19.
Go to step 6. Clean or replace
the feed roll,
separation roll,
and pick roll.
Go to
removal" on
page
"Separation roll
removal" on
page
"Pick roll
removal" on
page
Remove the Go to step 7.
media.
No
No
"Switch
4-19.
"Feed roll
4-45,
4-49, and
4-51.