Sensor (Exit 2) Static Jam - Lexmark W840 Service Manual

Step
8 Perform a print test.
Does the error still occur?
9 Perform a print test.
Does the error still occur?

203.03 Sensor (exit 2) static jam

Step
1 Check the media position.
Open the exit 2 left door assembly, and visually check it.
Does the media touch the sensor (exit 2)?
2 Check the sensor (exit 2) for proper operation.
1. Enter Diagnostics mode.
2. Select BASE SENSOR TESTS.
3. Select Media Path.
4. Select Exit2.
Open the printer left door assembly and the exit 2 left
door assembly.
Does the display on the operator panel change every
time the actuator on the above sensor operates?
3 Check the sensor (exit 2) for proper connection.
Is the above sensor connected properly?
4 Perform a print test.
Does the error still occur?
5 Perform a print test.
Does the error still occur?
Check
Check
Yes
Replace the exit Problem solved.
interface card
assembly.
Refer to the Printer
Service Manual.
Go to step 9.
Replace the printer Problem solved.
engine card
assembly.
Refer to the Printer
Service Manual.
Yes
Remove the media. Go to step 2.
Go to step 4. Go to step 3.
Replace the sensor Replace the
(exit 2). connection.
Go to "Exit 2
sensor (exit 2)
removal" on
page 4-206.
Replace the exit Problem solved.
interface card
assembly.
Refer to the Printer
Service Manual.
Go to step 5.
Replace the printer Problem solved.
engine card
assembly.
Refer to the Printer
Service Manual.
Diagnostic information
4024-XXX
No
No
2-97