Service Menu Overview - Pitney Bowes DM300c Service Manual

6 • Service Menus

6.1 Service Menu Overview

Service Menu Submenu 1
SBR Setup [only displays if SBR has not been done out of box or has been reset - see "Reset SBR Status" below]
Diagnostics PM Diagnostics
PM Maintenance
Feeder
Diagnostics
[DM400c/DM450c]
OR
Feeder/WOW
Diagnostics
[DM475]
SBR Diagnostics
[DM475]
Modem Diagnostics Modem Pass-Through [Engineering Use Only]
6-2
Submenu 2 Submenu 3
Motor Diagnostics Run Transport Motor
Run Tape Motor
Cap/uncap Print Head
Sensor Diagnostics S1 Transport
S2 Transport
S3 Transport
Jam Lever
Top Cover Open
Cap Home Pos.
Pump Home Pos.
Carriage Pos.
Print Head Vol.
Print Test Pattern Purge A, B, C, D
Clean Printer Nozzle Purge A, B, C, D
Replace Ink Tank [Same as opening ink access
cover]
Replace Print Head [Same as opening ink access
cover]
Motors Feeder Motor Excerciser
WOW Motor Excerciser [DM475] [Run at different speeds]
Sensors Feeder Sensors
WOW Sensors
Read Encoder Feeder Motor
WOW Motor [DM475]
Download Firmware [Engineering Use Only]
Reload Profiles [Engineering Use Only]
Print Logs [Engineering Use Only]
Save Logs to File [Engineering Use Only]
Information PCN Information
Counters
[View only feeder/
WOW numeric info]
Jam Counters
Length Calibration
Re-zero Thickness [Check encoder/reset to zero]
Last 256 Dimensions [Report of dimensions listed]
Reset SBR Status Reset Status
Don't Reset status
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
Submenu 4
Start Normal test
Stop Test
Run Encoder Full Rev.
Start Test
Status is displayed
[Displays either:
"Clear" or "Blocked
"Open" or "Closed"]
NOTE: S2 will always
show as Clear on 6C00
even thought there is no
.
S2 mounted on the board
[We recommend the re-
place print head purge]
[Run at different speeds]
["Clear" or "Blocked"
"Open" or "Closed"]
[Includes SBR sensors
and encoder]
[Encoder Status]
[Encoder Status]
XPT Entry
Length Error
WOW Timeout
Reset Counters
[makes it display on menu]