Feeder/Wow Registration Wall Alignment - Pitney Bowes DM300c Service Manual

5 • Removal & Replacement
WOW Section of Feeder/WOW Module (use for DM475)
5.56 Feeder/
WOW
Registration
Wall Alignment
5-66
This procedure aligns the registration wall of the feeder section with the
registration wall of the WOW section in the feeder/WOW module. This will
prevent mail pieces from hitting the WOW registration wall and ensure a
straight path for the mail piece.
NOTE: This procedure needs to be done any time the WOW unit chas-
sis has been removed from the machine, or if the machine is experiencing
jams/skews/no prints that suggest registration wall misalignment.
1. Locate and lock-down the three WOW load cell shipping screws. The
two front screws are accessed via notched holes in the feeder/WOW
deck (left photo below), while the back screw is accessed in a hole in
the interface cable compartment (right photo below).
Notched Access Holes on Deck
2. Remove the feeder/WOW module cover (section 5.39).
3. Remove two screws on top of metal frame for feeder/WOW control
board and one screw holding metal frame to bottom chassis.
Access Hole Inside Interface Cable Cavity
(interface cables shown disconnected)
Top Screws (remove)
Bottom Screw for
chassis (remove)
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)