Feeder Unit - Pitney Bowes DM300c Service Manual

Auto-Feeder (use for DM400c/DM450c/DM475)
5.27 Feed Deck

5.28 Feeder Unit

DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
Operating Note:
Maximum stack weight is 4.5
pounds. Weights greater than
this will cause the belts to skip
and consequently erratic or fail-
to-feed conditions.
Service Note:
You can eliminate or reduce
drive component noise by ap-
plying a small amount of silicone
lubricant to the offending parts.
1. DM400c/DM450c - Remove
entire printer/base assembly
from its base pan (see section
5.6 and figure, right).
2. DM400c/DM450c - Disconnect
three harnesses from PCB:
J309, J307, and J301
DM475 - Remove two screws
for moistener deck (one is
self-tapping in hole).
3. Remove feed deck (section
5.27).
5 • Removal & Replacement
Figure 5-87 Moving the Stack Present Sen-
sor Flag to provide Clearance
Figure 5-88 Feed Deck Mounting Tab
Figure 5-89 DM400c/DM450c Printer/Base
Removed from Base Pan
5-29