Feeder/Wow Junction Board; Wow Ws2 (Middle) And Ws3 (Exit) Sensors - Pitney Bowes DM300c Service Manual

WOW Section of Feeder/WOW Module (use for DM475)
5.43 Feeder/
WOW Junction
Board
5.44 WOW
WS2 (Middle)
and WS3 (Exit)
Sensors
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
1. Remove Feeder/WOW Control Board (section 5.41).
2. Unplug all connectors (three on top, three ribbon in the middle, and one
on bottom right) and remove two screws.
3. Reassemble in reverse order.
Screws
1. Remove Feeder/WOW Control Board (section 5.41).
2. Unplug purple harness (you may need to undo plastic clips).
3. Remove screw holding bracket to frame.
4. Remove screw holding sensor to bracket.
5. Reassemble in reverse order.
NOTE: Both sensors use the same part number.
WS3 Exit Sensor
5 • Removal & Replacement
Top Connectors
Middle Connectors
Bottom Right Connector
WS2 Middle Sensor
5-47