Retard Roller - Pitney Bowes DM300c Service Manual

5 • Removal & Replacement
Auto-Feeder (use for DM400c/DM450c/DM475)
5.30 Retard
Roller
5-32
1. Remove feeder PCB assem-
bly as described in section
5.29.
2. Remove one screw (figure,
right), and detach the en-
trance guide.
3. Remove two springs (4S3-
2380) as shown in figure,
right.
IMPORTANT! The four re-
maining springs (4S3-2379)
used in this assembly have
a different spring rate. The
springs are not interchange-
able. Note the location of and
mark each spring set so you
can return each to the correct
position when you reassem-
ble the unit.
CAUTION! Failure to do so
will change the tension ap-
plied to the pressure rollers
and compromise feeding.
Entrance Guide
Figure 5-95 Removing Entrance Guide
Springs
Figure 5-96 Removing Springs
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
Screw