5 • Removal & Replacement
WOW Section of Feeder/WOW Module (use for DM475)
5.50 WOW
Deck
5-54
1. Separate the feeder/WOW module from the printer/base (section 5.38)
2. Remove five screws from deck (one is embedded in a deep slot on the
left, one is in the right back corner under upper transport).
Screws for WOW Deck (Circled)
3. Disconnect width sensor cables from their sensors (section 5.49).
4. Open WOW jam clearance lever.
5. Lift deck plate up and slide the cables out of the opening in the back.
NOTE: Be careful not to damage the WOW width sensors flex cables
under deck.
6. Reassemble in reverse order. Keep in mind the following:
•
The three width sensor flex cables are not labelled and are attached
together – do not try to separate them. The longest flex cable on the
deck side goes to the outer sensor (WS5).
Screw Under Upper
Transport (Circled)
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)