Wow Section Of Feeder/Wow Module (Use For Dm475); Feeder/Wow Cover; Feeder Unit Of Feeder/Wow Module - Pitney Bowes DM300c Service Manual

WOW Section of Feeder/WOW Module (use for DM475)

5.39 Feeder/
WOW Cover
5.40 Feeder
Unit of Feeder/
WOW Module
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)
1. Separate the feeder/WOW module from the printer/base (section 5.38).
2. Remove water bottle.
3. Remove screws (nine in total) holding cover to chassis - five on back,
one on each side, and two on top (when cover is open).
4. Lift cover straight up.
5. Reassemble in reverse order.
NOTE: When reassembling,
be careful not to disturb the
left grounding screw on the
bottom chassis, as this screw
connects the grounding tab
between the feeder/WOW
cover and the rear grounding
plate.
1. Remove water bottle, moistener stripper blade/brush, and moistener
tank.
2. Remove the feeder/WOW module cover (section 5.39).
3. Remove side guide by removing screw at end of shaft behind the rear
wall (section 5.26).
4. Remove feed deck (section 5.27). Note that the DM475 feed deck has
eight screws. The ground screw on left side should be left intact.
5. Continue with step 6 in section 5.28 to remove the feeder unit from the
machine.
6. Reassemble in reverse order.
5 • Removal & Replacement
Cover
Grounding
Screw
Feeder Unit
(in white
rectangle)
5-43