Carriage Drive Motor - Pitney Bowes DM300c Service Manual

5 • Removal & Replacement
Printer/Base (use for all models)
5.10 Carriage
Drive Motor
5-10
1. Remove all printer/base covers (sections 5.2, 5.3, 5.4, and 5.6).
2. Disconnect two harnesses from purge unit as shown (Figure 5-24). This
is necessary to provide clearance.
3. Unscrew plastic wire loom (one screw) and let hang as shown (Figures
5-24 and 5-25).
4. Disconnect motor harness.
5. Unscrew motor mounting bracket (two screws). See Figure 5-25.
6. Remove motor and bracket (Figure 5-26).
7. Remove motor from bracket (four screws). See Figure 5-27.
8. Reassemble in reverse order.
Figure 5-24 Disconnect Harnesses and
Unscrew Wire Loom
Figure 5-26 Remove Motor and Bracket
Assembly; Remove Carriage Drive Belt
Disconnect
Harnesses
Figure 5-25 Let Wire Loom Hang;
Unscrew Two Motor Mounting Screws
Figure 5-27 Remove Motor from
Bracket Assembly
DM300c/DM400c/DM475 Service Manual (SV61801 Rev. D)