Information Codes Table - Panasonic UF-490 Service Manual

4.7. Information Codes Table (For Facsimile)
Code Mode
001 RCV
COPY
007 RCV
COPY
010 RCV
COPY
012 RCV
021 STANDBY
RX
COPY
030 XMT
031 XMT
COPY
041 STANDBY
RX
COPY
043 STANDBY
RX
COPY
044 RCV
COPY
045 STANBY
046 STANDBY
RX
COPY
051 RCV
COPY
054 STANDBY
RX
COPY
061 -
212
XMT
RCV
Fax Information Codes
Phase Description of Problem
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor.
C, D 1.Leading edge of the recording
paper fails to reach the Paper
Exit Sensor.
2.Recording paper has not
completely passed the Paper
Exit Sensor.
B, C No recording paper.
C, D The length of the received
document is over 2 meter (78.7in).
B, C, D Thermistor is abnormal.
Fuser Control is abnormal.
Fan is abnormal.
B Read Point Sensor does not go
ON within 10 seconds after the
document starts feeding.
C Transmitting document was longer
than 2 meter (or 78.7 in).
B, C, D Out of toner.
B, C, D Low toner.
- OPC Drum Unit maintenance.
- No Toner Cartridge.
Time to replace Drum Unit.
-
- Motor abnormal.
- HSYNC abnormal.
Motor abnormal.
A ADF Cover is open.
A-E Interface error occurred between
the CPU and modem.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Paper Exit Sensor abnormal.
No recording paper or paper is not set
properly.
No Paper Sensor is defective.
Defective SC PCB.
Defective Fuser Unit, Power Supply
Unit.
Defective Fan.
Document is not set properly.
Defective Read Point Sensor.
The document may jam.
Defective Read Point Sensor.
No toner.
Defective Toner Sensor.
Toner is getting low.
Defective Toner Sensor.
Reached the number of regulation for
printing.
Toner cartridge has not been installed.
Defective Toner Sensor
(Cartridge Sensor).
Drum use rate is reached 100%.
(Approx. 12,000 to 20,000 pages)
Connector not properly connected.
Defective Motor.
Defective SC PCB.
Defective Laser Unit.
Cover is not firmly closed.
Connectors are not firmly connected.
Modem is defective. (SC PCB)
Software problem occurred. (SC PCB)
106
Cause