Panasonic UF-490 Service Manual page 119

5.1.2. Service Mode 1 (Function Parameter Setting)
Use the following procedure to change the function parameters.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
4 Press "1".
5 Enter the Function Parameter Number or press "V" or
"/\ " to select the desired parameter.
Ex: Changing the "ALARM STATUS" -- Enter "001" and
press [SET].
6 Press "START".
7 Enter the new setting value. Ex: Enter "3" for Constant.
8 Press "START". The new value will be stored and the
next parameter will be displayed.
9 Repeat steps 4 through 7 to change other Function
Parameters or Press "STOP" twice to return to standby.
Note:
The following buttons provide these functions in the Service Mode:
"START" : The new setting value is stored in the machine.
"V" : Scroll the function parameter number down.
"/\" : Scroll the function parameter number up.
Service Mode 1
Operation or Unit Condition
119
LCD Display
OCT-12 10:58 00%
SET MODE (1-8)
SERVICE MODE
ENTER PARAM. #_
ALARM STATUS ?
Timer
Const.
STOP COMM.JRNL?
OCT-12 10:58 00%