Panasonic UF-490 Service Manual page 151

5.1.7. Service Mode 7 (LBP Service Mode)
This Service Mode is used to change printer parameters and verify printer information.
Use the following procedure to change printer parameter.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
4 Press "7".
5 1) Press "START" for printer parameter settings.
2) Press "2" and "START" to get the printer information.
Ex: Enter "START" for printer parameter settings.
6 Press "3" and "START".
Then enter the number of pages.
Ex: Enter "50" and press "START".
7 Press "STOP" twice to return to standby.
Sub-Code
1 SET LBP PARAM.
2 DISP. LBP INFO.
Service Mode 7
Operation or Unit Condition
Parameter Name
1 PRINTER COUNTER Displays and resets the Printer and
2 LBP FUSER RESET
3 OUT OF TONER
PRINT AVAILABLE
\/ /\
\/ /\ LBP MEM. CAPACITY Shows the Page Memory Capacity.
Paper Tray counters.
Clears the LBP Fuser Error.
Sets the number of pages to print after
low toner is detected.
Shows the remaining number of
allowable printable pages after low toner
has been detected (Counter Only).
151
LCD Display
OCT-12 10:58 00%
SET MODE (1-8)
SERVICE MODE
SET LBP PARAM.
PRINTER COUNTER
OUT OF TONER
OCT-12 10:58 00%
Description