Troubleshooting; Information Code Table - Panasonic UF-890 Service Handbook

3 Troubleshooting

3.1

Information Code Table

Code Mode
001 RCV
COPY
002 RCV
COPY
003 RCV
COPY
007 RCV
COPY
008 RCV
COPY
010 RCV
COPY
011 STANDBY
012 RCV
021 STANDBY
RX
COPY
026 -
030 XMT
031 XMT
COPY
033 -
041 STANDBY
RX
COPY
043 STANDBY
RX
COPY
045 STANDBY
Information Codes
Phase Description of Problem
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor. (1st cassette)
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor. (2nd cassette)
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor. (3rd cassette)
C, D 1.Leading edge of the recording
paper fails to reach the Exit
Sensor.
2.Recording paper has not
completely passed the Exit Sen-
sor.
C, D Paper Cassette was opened while
the recording paper was feeding.
B, C No recording paper.
- Paper Cassette is not installed
properly.
C, D The length of the received
document is over 380mm.
(Used in France only)
B, C, D Fan is abnormal.
Thermistor is abnormal.
Fuser Control is abnormal.
- The backup battery is getting
weak.
B Read Point Sensor does not go
ON within 10 seconds after the
document starts feeding.
C Transmitting document was longer
than 2,000mm (or 78.7 in).
- Sub CPU system error.
B, C, D Out of toner.
B, C, D Low Toner.
- No Toner Cartridge.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Exit Sensor abnormal.
Recording paper jam.
No recording paper or paper is not
set properly.
No paper Sensor is defective.
Defective LPC PCB.
Defective Fuser Unit, LVPS or
Fan.
Document is not set properly.
Defective Read Point Sensor.
The document may jam.
Defective Read Point Sensor.
Defective FCB PCB.
No toner.
Defective Toner Sensor.
Toner is getting low.
Defective Toner Sensor.
Toner cartridge has not been
installed.
Defective Toner Sensor
(Cartridge Sensor).
17
Cause