Panasonic UF-490 Service Manual page 122

No. Parameter
032 V34 TX START
033 V34 RX START
034 V34 TX Symbol
Rate
035 V34 RX Symbol
Rate
036 Not Used
037 PROTOCOL
DISPLAY
038 Not Used
039 FLASH TIME
040 E/F TIME
(Except for USA
and Canada)
041 PAUSE TIME
042 Not Used
043 REDIAL
INTERVAL
044 REDIAL COUNT 0 = no redial
045 RING DETECT
COUNT
046 ON-HOOK TIME 0 = 0 sec.
047 RESPONSE
WAIT
048 Not Used
049
050 RING DETECT
MODE
051 Not Used
052 PULSE RATE
Function Parameter Table
Selections
2400-33600bps
2400-33600bps
2400-3429sr
2400-3429sr
1 = Off (not displayed)
2 = On (displayed)
5 = 50 ms
~
100 = 1000 ms
5 = 50 ms
~
100 = 1000 ms
1 = 1 sec.
~
10 = 10 sec.
0 = no waiting
~
15 = 15 minutes
~
15 = 15 times
1 = 1 ring
~
9 = 9 rings
~
90 = 90 sec.
1 = 1 sec.
~
90 = 90 sec.
1 = Normal
2 = Rough
1 = 10 pps
2 = 20 pps
Selects the transmission modem start speed for V.34
communication, 33600-2400 bps.
Selects the receiving modem start speed for V.34
communication, 33600-2400 bps.
Selects the transmission symbol rate for V.34, 3429/
3200/3000/2800/2400 sr.
Press "V" or "/\ " to select the symbol rate.
Selects receiving symbol rate for V.34, 3429/3429/
3200/3000/2800/2400 sr.
Press "V" or "/\ " to select the symbol rate.
Selects whether to display the modem speed during
communication.
(Press the Job Status Key to display)
Selects the pause interval before activating the Flash
key.
Selects the pause interval before activating the Flash
key.
Selects the pause interval from 1 sec. ~ 10 sec. for
dialing through a switchboard or for international
calls.
Selects the redial interval from 0 to 15 minutes in 1
minute steps.
Selects the redial count from 0 to 15 times in 1 step
intervals.
Note:
In order to comply with the requirements TBR21 in
the EC countries, do not select 15 times.
Selects the ring detection count from 1 to 9 rings in 1
ring step intervals.
Selects the on-hook time between sequential
communication calls in 1 second step intervals.
Selects the waiting interval for the response after
completing the dialing.
Selects the quality of ringer detection. Use if the line
signal is out of regulation, set to "Rough" so that the
unit may detect the ringing signals.
Selects the dial pulse rate 10/20 pps.
122
Function