Panasonic UF-490 Service Manual page 110

Code Mode
601 XMT
623 XMT
630 XMT or RCV
(Polling)
631 XMT
634 XMT
638 XMT
741 XMT, Polling
800 Relay
Comm.
816 Conf. Polled
870 MEM XMT
Multi-Copy
880 -
884 -
887 -
Fax Information Codes
Phase Description of Problem
ADF Door was opened during ADF
transmission.
A No original was in the ADF. (Built-
in dialer engaged)
B Redial count over.
A "STOP" button was pressed during
Auto Dialing.
Redial count over with no response
or busy tone was not detected.
Note:
U.S.A. and Canadian models
will redial only once if a busy
tone is not detected.
Power turned off with applicable
data in memory or during
communication.
Unable to dial
The machine was requested to
relay a document but has no Relay
Hub capability.
"The received Polling Password
did not match. The machine does
not have Confidential Comm.
capability."
Memory overflow occurred while
storing documents into memory.
- File Access Error.
- File Access Error.
- Power Failure.
Operator removed the original from the
ADF after dialing was completed.
Original was not set properly in the ADF.
No dial tone detected. Sensor dial tone
is not detected. (country dependent)
Busy tone is detected. (country
dependent) T1 timer (35±5 sec.)
elapsed without a signal from the
receiver.
Power switched off. Power failure
occurred.
Deleted the registered station name
before dialing with Timer Controlled
Communications, etc.
110
Cause