ZyXEL Communications NBG-418N v2 User Manual page 89

Table 35 Network > WAN > IPv6 (IPv6 in IPv4 Tunnel)
LABEL DESCRIPTION
Address Autoconfiguration Settings
Enable Click Enable Autoconfiguration if you want the devices on your local area network to
Autoconfiguration obtain network address that are not managed by a DHCPv6 server.
Autoconfiguration Select SLAAC + Stateless DHCPv6 if you want the interface to automatically generate
Type a link-local address via stateless autoconfiguration.
Select Stateful(DHCPv6) when the devices connected to your LAN needs to have their
TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router Type in the Router Advertisement Lifetime which is amount of time in minutes that a
Advertisement device may have an IPv6 address before it is required to renew the lease.
Lifetime
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
Figure 62 Network > WAN > IPv6 (6 to 4)
The following table describes the labels in this screen.
Table 36 Network > WAN > IPv6 (6 to 4)
LABEL DESCRIPTION
IPv6 Connection 6 to 4 is an IPv6 address assignment and automatic tunneling technology that used to
Type provide unicast IPv6 connectivity between IPv6 sites and hosts across the IPv4 Internet.
6 to 4 Settings
6 to 4 Address Enter a 6 to 4 IP address in this field. This information is provided by your ISP.
6 to 4 Relay Type the ISP's border relay server's IPv6 address in this field.
Chapter 7 WAN
NBG-418N v2 User's Guide
89