ZyXEL Communications NBG-418N v2 User Manual page 84

Table 32 Network > WAN > IPv6 (continued)(Static IPv6)
LABEL DESCRIPTION
Address Autoconfiguration Settings
Enable Click Enable Autoconfiguration if you want the devices on your local area network to
Autoconfiguration obtain network address that are not managed by a DHCPv6 server.
Autoconfiguration Select SLAAC + Stateless DHCPv6 if you want the interface to automatically generate
Type a link-local address via stateless autoconfiguration.
Select Stateful(DHCPv6) when the devices connected to your LAN needs to have their
TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router Type in the Router Advertisement Lifetime which is the amount of time in minutes
Advertisement that a device may have an IPv6 address before it is required to renew the lease.
Lifetime
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
Figure 59 Network > WAN > IPv6 (SLAAC/DHCPv6)
The following table describes the labels in this screen.
Table 33 Network > WAN > IPv6 (SLAAC/DHCPv6)
LABEL DESCRIPTION
IPv6 Connection Select SLAAC/DHCPv6 when your NBG-418N v2 requests an IPv6 address from the
Type ISP's server.
IPv6 DNS Settings
Obtain DNS server Click the Obtain DNS server address automatically radio button to get a DNS server
address address from your ISP's server.
automatically
Chapter 7 WAN
NBG-418N v2 User's Guide
84