ZyXEL Communications NBG-418N v2 User Manual page 87

Table 34 Network > WAN > IPv6 (continued)(PPPoE)
LABEL DESCRIPTION
Connection Type Select Continuous if you do not want the connection to time out.
Select Connection on Demand if you want to connect for a certain amount of time
before the router automatically disconnects from the PPPoE server. If you select this you
will need to enter the number of minutes in the Idle timeout field.
Select Manual if want to make the connection manually.
Connect/ Click Connect to establish PPPoE connection to IPv6 Internet or click Disconnect to
Disconnect stop the connection.
IPv6 DNS Settings
Obtain DNS Server Click the Obtain DNS server address automatically radio button to get a DNS server
address address from your ISP's server.
automatically
Use the following Click Use the following DNS address radio button to use a fixed DNS address.
DNS address
Primary/Secondary Enter the Primary and Secondary DNS address for the IPv6 server in the appropriate
DNS Address box fields.
Lan IPv6 Address Settings
Enable DHCP-PD Click Enable DHCP-PD (DHCP-Prefix delegation) to allow NBG-418N v2 assign prefixes
to DHCP clients.
LAN IPv6 Address Enter the IPv6 IP address for the LAN interface in this field.
LAN IPv6 Link-Local Enter the IPv6 Link-local address in the LAN side. This is used by NBG-418N v2 when
Address communicating with neighboring devices on the same link. It allows IPv6-capable
devices to communicate with each other in the LAN side.i
Address Autoconfiguration Settings
Enable Click Enable Autoconfiguration if you want the devices on your local area network to
Autoconfiguration obtain network address that are not managed by a DHCPv6 server.
Autoconfiguration Select SLAAC + Stateless DHCPv6 if you want the interface to automatically generate
Type a link-local address via stateless autoconfiguration.
Select Stateful(DHCPv6) when the devices connected to your LAN needs to have their
TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router Type in the Router Advertisement Lifetime which is amount of time in minutes that a
Advertisement device may have an IPv6 address before it is required to renew the lease.
Lifetime
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
Chapter 7 WAN
NBG-418N v2 User's Guide
87