Ink And Replenisher Procedures Draining Fluids; Figure 3 Vent Fitting, Installed On Replenisher Tank - Kodak VERSAMARK DP7122 User Manual

Ink and Replenisher Procedures
Draining Fluids
Draining Fluids
Vent fitting
8
Use the following procedure to drain the ink and replenisher from the
7122 printer:
1. Check that the printer is ready for service (see "Printer Preparation").
2. Put on gloves and eye protection.
Avoid spilling ink and avoid direct contact with ink.
3. Attach the drain tubing (0101070-090) to one of the quick disconnect
fittings (0101099-202).
4. Open both doors of the fluid cabinet.
5. Plug the second quick-disconnect fitting into the unused quick
disconnect on top of the tank (see Figure 3).
The second quick-disconnect fitting is used as a tank vent. Venting
accelerates the emptying of the tank. If you do not vent it, the tank will
take at least 30 minutes to drain and may not drain completely.
Note: Which tank is drained first is not significant. Draining the rear (replenisher)
tank first prevents having to reach over any dripped or spilled fluid to
connect the fittings.
Figure 3 Vent fitting, installed on replenisher tank