Samsung OfficeServ 7100 Technical Manual page 364

OfficeServ 7100
TECHNICAL MANUAL
3. NEXT ROUTE:
LCR
TRUNK Number
TRUNK GROUP
Number
In addition to the 198 table entries there are two special entries, 199 and 200. Entry
199 is used to route failed calls and entry 200 is used to route calls with no
matching entry. These entries are programmed as follows:
199. FAIL ROUTE:
200. NO MATCH RT: This option determines where the received digit string will be
PROGRAM KEYS
VOLUME UP & DOWN
KEYPAD
RIGHT & LEFT SOFT KEYS
SPEAKER
HOLD
ACTION
1. Press TRANSFER 763.
Display shows.
2. Dial table entry number (e.g. 105)
OR
MMC: 763
This option determines where the translated OUT DIGIT string
should be sent. Valid entries are as follows:
The OUT DIGIT string will be sent to the system LCR for
further routing. This is the default setting.
This trunk will be accessed to send the OUT DIGIT string.
A trunk out of this group will be accessed to send the
OUT DIGIT string.
This option determines where the IN DIGIT string will be sent
if the translation routine fails. This can occur if the specified
trunk route is busy or out of order. By default this value is
set to LCR. Valid entries are the same as the NEXT ROUTE
option above.
sent if there are no matching IN DIGIT entries in the table.
By default this value is set to LCR. Valid entries are the same
as the NEXT ROUTE option above.
Used to scroll through options
Used to input selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear current entry
Home Page
PROGRAMMING
PART 2 JANUARY 2009
DISPLAY
(001)IN DIGIT
(001)IN DIGIT
Table of Contents