Building A Dialing Translation Table - Nortel CallPilot 100 Administration Manual

Building a Dialing Translation Table

To build a Dialing Translation Table, you must enter an Input value and an Output value for each
entry. The Input value is the number that the CallPilot 100/150 looks up in the Dialing Translation
Table. If the corresponding entry matches, the system substitutes the Output value for the Input
value. The resulting number is ready to dial on the local network. Refer to
Dialing Translation Table from a site in metropolitan Toronto" on page
To build a Dialing Translation Table
Log:
QUIT RETRY
Admin
MBOX AA
Dialing
PARM TABLE
Dial Table
ADD CHNG
In: xxx
RETRY
xxx
RETRY
Out:
RETRY
xxx
RETRY
Dial Table
ADD CHNG
Press ≤·°‹.
1
OK
Enter the System Administrator Mailbox number and password,
then press OK.
2 Press °°
OTHR
Press TABLE.
3
QUIT
Press ADD.
4
QUIT
5
Enter an input value up to 14 digits.
OK
Press OK to accept the input value
6
OK
or
press RETRY and enter a new input value.
7 Enter an output value up to 15 digits.
OK
Press OK to accept the output value
8
OK
or
press RETRY and enter a new output value.
Press ® to end the session.
9
QUIT
Chapter 10 Dialing Translation
. This option does not appear as a display button option.
CallPilot Telephone Administration Guide
"An example of a
122.
125