Building A Dialing Translation Table - Nortel CallPilot 100 Set Up And Operation Manual

Building a Dialing Translation Table

To build a Dialing Translation Table, you must enter an Input value and an Output value for each
entry. The Input value is the number that the system looks up in the Dialing Translation Table. If
the corresponding entry matches, the system substitutes the Output value for the Input value. The
resulting number is ready to dial on the local network. Refer to
Tables" on page 31
To build a Dialing Translation Table
1 Start CallPilot Manager.
2 Click the Configuration heading.
3 Click the Dialing Translation Table link.
The Dialing Translation Table page appears.
4
Click the Add button.
The Dialing Translation Setup page appears.
5 In the Input Value box type the input value.
6 In the Output Value box type the output value.
7
Click the Submit button.
for examples of Dialing Translation Tables.
CallPilot Message Networking Set Up and Operation Guide
Chapter 3 Setting up AMIS
"Examples of Dialing Translation
35