Canon iPF6100 Service Manual page 156

(4) The Roll Feed Unit [1] is preinstalled on the
printer. Peel away the tape and remove the Roll
Holder [2] and protective material from the Roll
Feed Unit. Also remove the tape on the two Holder
Stoppers attached to the Roll Holder, and then
remove the Holder Stoppers from the Roll Holder.
[1]
(5) Remove the tape and other packaging material
used to secure the printer and accessories. Remove
the tape and protective material on the Top Cover [1]
and Ejection Guide [2]. After removing the tape and
protective material on the Ejection Guide, reinstall it.
F-3-7
[1]
[2]
F-3-8
(6) Lift the Belt Stopper [2] of the Carriage Shaft [1]
and pull it forward to remove it.
[2]
MEMO:
- You will need the Belt Stopper if you move the
printer to another location. Do not discard the Belt
Stopper you have removed.
- When you open the Top Cover, you will find a
Cleaning Brush [3] on the right side. Use this brush
to clean inside the Top Cover.
(7) Plug the power cord into the Power Socket on the
back of the printer.
(8) Plug the power cord into the outlet.
Chapter 3
[2]
[1]
[3]
F-3-9
F-3-10
F-3-11
3-5