KitchenAid KEMS378S Technical Education page 34

c) Disconnect the wires from the main L1
filter board as follows:
White at P31 (to 3-pin plug)
Black at P32
Brown at P33
White at P34
d) Remove the mounting screw and re-
move the board from the bracket.
P32 BK
Screw
P33 BR
Main L1 Filter
6. To remove the main L2 filter:
a) IMPORTANT: Discharge the main L2
filter by touching the leads of a 20,000
ohm resistor to the terminals and chas-
sis ground.
b) Remove the nut and washer from the
main L2 filter stud and remove the filter.
Main L2 Filter Nut & Washer
c) Disconnect the wires from the main L2
P31 WH
P34 WH
7. To remove the grill thermostat:
a) IMPORTANT: Discharge the main L2
b) Remove the main L2 filter and move it
c) Disconnect the wires from the thermo-
d) Remove the two screws from the ther-
4-12
filter terminals.
Main L2 Filter
GN/YL (GND)
WH (PLUG)
BK (THERMOSTAT)
filter by touching the leads of a 20,000
ohm resistor to the terminals and chas-
sis ground.
out of the way of the thermostat (see
step 6 for the procedure).
stat terminals.
mostat and remove the thermostat.
Grill Thermostat
BK Wires
Screw (1 of 2)
RD (PLUG)
RD (RELAY)