c) Disconnect the convection thermistor
connector from appliance manager con-
nector P6 and remove the thermistor.
REASSEMBLY NOTE: Install the convection
thermistor and clip first, then place the insulation
and insulation cover over the thermistor.
7.
To remove the grill element:
a) From the rear of the oven, disconnect
the three wires from the grill element
terminals.
b) Remove the two nuts from the grill ele-
ment studs.
MW Grill Wires
MW Grill Nuts
Conv. Therm.
Connector P6
4-17
c) Open the microwave oven door.
d) Twist the front grill element support 90°
in either direction and remove it from
the cavity slot.
Front MW Grill Element Support
e) Lower the front of the grill element,
pull the element terminals out the back
holes of the cavity, and remove the ele-
ment.
MW Grill Element