Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
CONVECTION RING ELEMENT
Refer to page 4-32 for the procedure for ac-
cessing the convection ring element.
NOTE: The convection ring element will be
tested at the appliance manager board (see
page 4-18).
1.
Unplug oven or disconnect power.
2.
Set the ohmmeter to the R x 1 scale.
3.
Touch the ohmmeter test leads to wire con-
nectors T3-2 (YL) and T2-2 (R/W). The meter
should indicate between 33 and 37 Ω.
T2
1 2 3 4 5
Lower Oven
Appliance Manager
T3
WARNING
Electrical Shock Hazard
CONVECTION FAN MOTOR
Refer to page 4-32 for the procedure for ac-
cessing the convection fan motor.
NOTE: The convection fan motor will be tested
at the appliance manager board (see page
4-18).
1.
Unplug oven or disconnect power.
2.
Set the ohmmeter to the R x 1 scale.
3.
Touch the ohmmeter test leads to wire
connector P8-3 (OR) and the neutral (WH)
stud on the AC terminal block. The meter
should indicate approximately 18 Ω.
Lower Oven
Appliance Manager
5-12
P8
1 2 3 4 5 6