Removing The Blower Assembly, Blower Seed Resistor, And Oven Shutdown Thermal Cutoff - KitchenAid KEMS378S Technical Education

REMOVING THE BLOWER ASSEMBLY, BLOWER SPEED
RESISTOR, AND OVEN SHUTDOWN THERMAL CUTOFF
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug oven or disconnect power.
2. Remove the oven from its mounting location
(see "Installation Information" in Section 2)
and pull it forward so that you can access
the top cover.
3. Remove the four screws from the top cover
and remove the cover.
Top Cover
Screws (2 of 4)
4. Remove the ten screws from the upper rear
cover of the oven and remove the cover.
Upper Rear Cover
(10 Screws)
5.
Upper Rear Cover
6.
4-36
Blower
Blower Speed Blower Motor
Resistor
To remove the blower assembly:
a) Disconnect the white and gray wires
from the blower motor terminals.
b) Remove the two screws from the blower
brackets.
c) Pull back on the blower assembly while
rotating it upwards and remove the as-
sembly.
Blower Motor Wires
To remove the blower speed resistor:
a) Disconnect the two gray wires from the
resistor terminals.
b) Remove the screw from the resistor
bracket and remove the resistor.
Blower Speed
Resistor Wires
Screw
Oven Shutdown
TCO
Screws