Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
MAGNETRON FAN MOTOR
Refer to page 4-13 for the procedure for ac-
cessing the magnetron fan motor.
1.
Unplug oven or disconnect power.
2.
Disconnect one of the wires from the mag-
netron fan motor terminals.
3.
Set the ohmmeter to the R x 1 scale.
4.
Touch the ohmmeter test leads to the mo-
tor terminals. The meter should indicate
approximately 3 Ω.
WARNING
Electrical Shock Hazard
MICROWAVE INVERTER BOARD
CN701
Refer to page 4-13 for the procedure for ac-
cessing the inverter.
1.
Unplug oven or disconnect power.
2.
Visually inspect connectors CN701,
CN702, CN703, and E701 on the micro-
wave inverter board and check for signs of
overheating, or any failures due to loose
wires, bad crimping, etc.
5-6
CN702
E701
CN703