Removing The Convection Thermistor And Grill Element - KitchenAid KEMS378S Technical Education

REMOVING THE CONVECTION THERMISTOR
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug oven or disconnect power.
2. Remove the oven from its mounting location
(see "Installation Information" in Section 2)
and pull it forward so that you can access
the top cover.
3. Remove the four screws from the top cover
and remove the cover.
Screws (2 of 4)
4. Remove the ten screws from the upper rear
cover of the oven and remove the cover.
Upper Rear Cover
(10 Screws)
AND GRILL ELEMENT
Top Cover
5. Remove the seven screws from the outer
convection cover and remove the cover.
Outer Convect. Cover
MW Grill Element Terminals
Convection Thermistor
6. To remove the convection thermistor:
a) Remove the convection thermistor,
insulation, and insulation cover from
the thermistor.
b) Remove the screw from the convection
thermistor clip and remove the clip and
thermistor.
Insulation & Cover
4-16
(7 Screws)
Conv. Therm.
Clip Screw