Changing Tv Format; Removing Hdmi Video Output Up-Scaling Limits; Recovery And Backup Of The System Settings; Initializing Various Settings For This Unit - Yamaha RX-A1000 Owner's Manual

Changing TV format

T V F O R M A T
Change the color encoding format of OSD to PAL (default) or
NTSC, to match the format used by the TV connected via the
HDMI OUT 1-2 or VIDEO (MONITOR OUT) jack.
Removing HDMI video output up-scaling
limits
M O N I T O R C H E C K
Removes the up-scaling limitation on video resolution when this
unit and a TV are connected via HDMI jacks.
If a resolution supported by the monitor cannot be detected when
configuring the up-scaling settings, this setting will remove the
output limitation.
YES (Default) Video output signals of a resolution not supported by
the TV will not be transmitted.
SKIP This unit ignores the TV's support capability and
transmits input video signals to the TV.
J
1 : After performing "RECOVERY," turn off this unit.
Recovery and backup of the system
settings
P A L
Save and restore the settings of this unit.
1 Press STRAIGHT repeatedly to select "BACKUP" or
"RECOVERY" and press INFO on the front panel.
Y E S
RECOVERY
BACKUP
Press INFO to execute the "BACKUP" or
2
"RECOVERY."
"RECOVERY" cannot be selected if settings have not be
previously saved.
Extended functionality that can be configured as needed (Advanced Setup menu)
R E C O V . / B A C K U P
B A C K U P
STRAIGHT
INFO
Restores settings for this unit that have been saved.
Saves the current settings of this unit.
J1

Initializing various settings for this unit

I N I T I A L I Z E
C A N C E L
Initializes various settings stored in this unit and sets it back to
default.
Select the items to be initialized from the following.
DSP PARAM
Initializes all parameters for the sound programs.
VIDEO
Resets video conversion settings (resolution/aspect
ratio) in the Setup menu.
NETWORK
Resets the settings of network such as IP address or
the account of vTuner.
ALL
Resets this unit to default factory settings.
CANCEL (Default)
Does not initialize.
When an option other than CANCEL is selected, the applicable
default settings will be restored when the unit switches to standby
mode.
SETUP
111
En