Yamaha RX-A1000 Owner's Manual page 21

Check that "SPEAKER IMP." is displayed on the
3
front panel.
S P E A K E R I M P .
8 M I N
4 Press STRAIGHT repeatedly to select a "6ΩMIN."
Switch this unit to the standby mode, and then
5
switch it on again.
The power turns on, when the settings you made has been
configured.
■
Connecting speakers
This type of jack can connect to the following speakers or
connection.
• Front L/R speakers
• Center speaker
• Surround L/R speakers
• Surround back L/R speakers
• Presence L/R speakers
• Zone2 speakers
• Bi-amp connection (Front L/R speakers)
J
1 : When using the only one subwoofer, connect the subwoofer to the
SUBWOOFER 1.
3
F R
O N
T
2 2
1
4 4
1 Remove approximately 10 mm of insulation from the
ends of the speaker cables, and twist the bare wires
of the cables together firmly so that they will not
cause short circuits.
2 Loosen the speaker terminals.
3 Insert the bare wire of the speaker cable into the gap
on the side of the terminal.
Tighten the terminal.
4
CONNECTIONS
Connecting speakers
■
Connecting the subwoofers
Connect the subwoofer input jack to the
1
SUBWOOFER 1 and/or 2 jack on this unit with an
J1
audio pin cable.
2 Set the subwoofer volume as follows.
Volume: Set to approximately half volume (or slightly less than
half).
Crossover frequency (if available): Set to maximum.
CROSSOVER/
HIGH CUT
VOLUME
MIN MAX MIN
Subwoofer examples
NOTE
After connection, applying this setting to this unit is required to
activate all speaker connections. With using "Power Amp
Assign" function, you can easily apply the speaker
configuration.
Refer to "Power Amp Assign" (☞p. 90) for details on using
"Power Amp Assign" function.
MAX
21
En