Adjusting This Unit's Network Parameters - Yamaha RX-A1000 Owner's Manual

Adjusting this unit's network parameters

Network setup items
IP Address Selects whether this unit acquires the network
parameters (IP address, etc.) from the network's
DHCP server automatically, or whether these
parameters are specified manually.
Network Standby Selects whether or not commands are accepted over
the network when this unit is in standby mode.
MAC Address Filter Sets the MAC address filter to restrict network access
to this unit.
■
Setting the network parameters (IP
address, etc.)
IP Address
Selects whether or not this unit automatically acquires network
parameters (IP address, subnet mask, default gateway, primary
DNS server and secondary DNS server) from a network device
such as a router equipped with DHCP function.
DHCP
Off Select this setting to specify IP address manually.
On (Default) Select this setting to acquire IP address from the
network's DHCP server automatically.
Manual Setup
IP Address Specifies the IP address assigned to this unit. An IP
address used by another device on the same network
may not be used.
Subnet Mask Specifies the subnet mask assigned to this unit.
Default Gateway Specifies the IP address of the default gateway.
DNS Server Specifies the IP addresses of the primary and
(Primary)/DNS secondary Domain Name System (DNS) servers.
Server (Secondary)
If you have only one DNS address, enter the DNS address in
"DNS Server (Primary)." If the network has two or more DNS
addresses, enter one of the addresses in "DNS Server (Primary)"
and another in "DNS Server (Secondary)."
Setting various functions (Setup menu)
■
Turning this unit on by the command over
the network when in the standby mode
Network Standby
Selects whether or not to turn this unit on by the command over the
network when in the standby mode.
Off (Default)
Disables to turn this unit on by the command over the
network.
On
Enables to turn this unit on by the command over the
network.
When "Network Standby" is set to "On," this unit can be turned
on by the command over the network during the standby mode
with the power consumption of about only 5 W.
■
Setting the MAC Address Filter
MAC Address Filter
Sets MAC address filter to restrict access to this unit via LAN.
Mode
Off (Default)
Disables the MAC address filter function.
On
Permits access to this unit only from network devices
with the specified MAC addresses.
Address Setup
Specifies the MAC addresses of network devices permitted to
access to this unit when "MAC Address Filter" is set to "On."
SETUP
98
En