Yamaha RX-A1000 Owner's Manual page 118

■
Connecting zone video monitors
Connect the video monitor(s) in Zone2 to MONITOR OUT/ZONE OUT jacks. If you connect the
multiple zone video monitors to these jacks, the video monitors play back the selected input source for
the Zone2.
To assign the MONITOR OUT/ZONE OUT jacks to the main zone or Zone2, configure "Monitor
Out Assign" (☞p. 99).
Source component
MON.OUT/ZONE OUT MON.OUT/ZONE OUT
Video in
Zone2
MONITOR OUT/ZONE OUT
Y P P
B R
This unit
or Component video in
V Y P P
B R
Video monitor
■
Controlling this unit with the remote control in another room
This unit is equipped with REMOTE IN and REMOTE OUT jacks. You can use these jacks to control
this unit and other components from Zone2
Some Yamaha models can be directly connected to the REMOTE jacks of this unit. These models
may not require an infrared signal emitter. Up to 6 Yamaha components can be connected as shown
below.
REMOTE
IN
Infrared signal This unit
receiver
SETUP
Enjoying the contents in another room
(☞p. 33).
REMOTE REMOTE
OUT IN OUT
Yamaha
component
En
118