Tuner (Fm/Am) - Yamaha RX-A1000 Owner's Manual

Tuner (FM/AM)

FM
Problem Cause
FM stereo reception
You are too far from the station
is noisy. transmitter, or the input from the
antenna is weak.
There is distortion, There is multi-path interference.
and clear reception
cannot be obtained
even with a good FM
antenna.
The desired station
You are in an area far from a
cannot be tuned into
station, or input from the antenna
with the automatic
is weak.
tuning method.
"No Presets" is
No preset stations are registered.
displayed.
"Wrong Station" is An invalid FM/AM frequency has
displayed.
been input.
See
Remedy
page
Check the antenna connections. 36
Switch to monaural mode. 61
Replace the outdoor antenna with a more —
sensitive multi-element antenna.
Adjust the antenna height or orientation, or —
place it in a different location.
Replace the outdoor antenna with a more —
sensitive multi element antenna.
TUNING H / I
Use to manually select the 59
station.
Register stations you want to listen to as 59
preset stations before operation.
Input a frequency that can be received. —
AM
Problem Cause
The desired station The signal is weak, or the antenna
cannot be tuned into
connections are loose.
with the automatic
tuning method.
Automatic station
Automatic station preset is not
preset does not
available for AM stations.
work.
Continuous
The supplied AM loop antenna is
crackling and
not connected.
hissing noises are
The noises may be caused by
heard.
lightning, fluorescent lamps,
motors, thermostats, or other
electrical equipment.
Buzzing and whining
A TV set is being used nearby.
noises are heard.
APPENDIX
Troubleshooting
See
Remedy
page
Adjust the AM loop antenna orientation. —
Use the manual tuning method. 59
Use manual station preset. 59
Connect the AM loop antenna correctly 36
even if you use an outdoor antenna.
It is difficult to completely eliminate noise, —
but it can be reduced by installing and
properly grounding an outdoor AM antenna.
Move this unit away from the TV set. —
123
En