NEC Electra Elite IPK II System User Manual page 1177

Electra Elite IPK II
To program a key, press Speaker key, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
Use this key...
Code: 38
Operation: Leave
message: Call ext +
Press key OR
Answer message:
Press key
Code: 39
Operation: Press
key at destination
and source + ext
Code: 40
Operation: Press
key
Code: 41 + sec. ext.
Operation: Press
key
Code: 42 + boss
ext.
Operation: Press
key
Code: 43
Operation: TRK call
+ Hold + ext + Press
key
Code: 44
Operation: Place or
answer call + Press
key
Code: 45
Operation: Place or
answer call + Press
key
Code: 46
Operation: Press
key
Code: 47 + dest.
ext.
Operation: Press
and hold key
Code: 48
Operation: Hear
Off-Hook Signaling
tones + Press key
Codes Tables
Table 3-5 Function Key Codes by Number (Continued)
press the key and enter the code (e.g., 48 for Voice Over).
For this feature...
Message Waiting
Room Monitor
Handset Cutoff
Secretary Call Call your secretary (using the
Serial Call
Hold
Department Calling
Reverse Voice Over
Voice Over
When you...
Answer/Leave a
Message Waiting
Activate Room Monitor
Cut off the handset
transmission while on a call
buzzer)
Are a secretary picking up a
call ringing your boss's
extension.
Place a Serial Call to a
co-worker
Put a call on System Hold (if
hold key is reassigned)
Put a call on Exclusive Hold
Log in or log out of your
Department Calling Group
Initiate Reverse Voice Over
Initiate or respond to Voice
Over
Document Revision 4C
Also see
Key Lamp Status
Srvc Code
None
Fast Flash red at
destination, Hold
Flash red at source
On when feature
active (no
transmission on
handset)
On red at source
Fast Flash red at
destination
On red when
activated
None
None
None
On when removed,
Off when installed
Full BLF red
On red when
responding Hold
Flash red when
listening
0

or
0
-
-
-
-
-
-
-
150
-
790
3 - 33