NEC Electra Elite IPK II System User Manual page 1051

Electra Elite IPK II
Programming

11-01-01 System Numbering
Set the systems internal (Intercom) numbering plan. The numbering plan assigns the first and
second digits dialed and affects the digits an extension user must dial to access other
extensions and features, such as service codes and trunk codes. If the default numbering plan
does not meet the site requirements, use this program to tailor the system numbering to the site.
Improperly programming this option can adversely affect system operation.
Make sure you thoroughly understand the default numbering plan before
proceeding.
Before changing your numbering plan, use PCPro or WebPro to make a
backup copy of your system data.

11-02-01 Extension Numbering
Set the extension number. The extension number can have up to eight digits. The first/second
digit(s) of the number should be assigned in Program 11-01-01. This allows an employee to
move to a new location (port) and retain the same extension number.
(default: 1~99 = 101~199, 100~256 = 3101~3257)

44-01-01 System Options for ARS/F-Route – ARS/F-Route Time Schedule
Set this option to 0 so that the F-Route table selected is determined only by the digits dialed
without any relation to the day or time of the call.
(default: 0)

44-02-01 Dial Analysis Table for ARS/F-Route Access – Dial
Set the number of digits (up to eight) to be analyzed by the system for ARS routing.
(default: No Setting)

44-02-02 Dial Analysis Table for ARS/F-Route Access – Service Type
Select the Service Type (0 = No Setting, 1 = Extension Call, 2 = ARS/F-Route Table, 3 = Dial
Extension Analyze Table).
(default: 0)

44-02-03 Dial Analysis Table for ARS/F-Route Access – Additional Data
Enter the additional data required for the service type selected in Program 44-02-02, either the
number of digits to be deleted or the table number to be used.
(default: 0)

44-02-04 Dial Analysis Table for ARS/F-Route Access – Dial Tone Simulation
If enabled (1), this option sends dial tone to the calling party once the routing is determined.
This may be required if the central office at the destination does not send dial tone.
(default: 0)

44-05-01 ARS/F-Route Table – Trunk Group Number
Select the trunk group number to be used for the outgoing ARS call (0~100).
[default: 0 (No Setting)]
Uniform Numbering Network
Caution
Document Revision 4C
2 - 1027