NEC Electra Elite IPK II System User Manual page 1005

Electra Elite IPK II
Conditions
When an analog device is a member of a Department Group assigned as the VM

Department Group in PRG 45-01-01, it cannot perform an unsupervised transfer. When
the party where the call is being transferred answers, the transferred party is connected to
that party, and the analog device is released.
An existing call can be transferred to a call with Barge-In enabled.

Unscreened Transfers from voice mail show pre-answer Caller ID information.

With Transfer to Busy Extensions enabled (Program 24-02-01 = 1), Call Forwarding with

Both Ringing offers a unique option. A transferred call waits for either the forwarding or
destination extension to become free. The call goes through to the extension that first
becomes available. If neither extension becomes free during the Transfer Recall Time, the
call recalls the transferring extension.
An existing call can be transferred to a conference call.

Meet Me Paging Transfer allows the user to page a co-worker and have the call

automatically transferred when the co-worker answers the page.
When transferring, an extension user can press a One-Touch key instead of dialing the

extension number.
Serial calls allow transferring a call so it automatically returns to the transferring extension

when completed.
When a multiline terminal user is on a call, they can press a DSS key for that station to

transfer to another station. It is not necessary to press Transfer to transfer to another
station with a DSS key.
When a multiline terminal user is on a call, they must press Transfer to transfer a call off site with

a DSS key.
The following features require certain tones be changed in PRG 80-01-02. Refer to the

table in the
Call Holding

Busy Greeting

Call Screening

Await Answer Transfer

A Trunk-to-Trunk transfer can be established by the following operation:

1. While talking to an outside party, press Hold.
2. Access a second outside line and dial the desired number.
3. Press Transfer to complete the Trunk-to-Trunk transfer.
When the second call is to be transferred (Not Trunk-to-Trunk), the user should press Hold at

step 3, then dial the desired station and press Transfer to complete the transfer.
Transfer
Digital Voice Mail feature programming section for settings:
Document Revision 4C
2 - 981