NEC Electra Elite IPK II System User Manual page 1011

Electra Elite IPK II

25-06-02 VRS/DISA One-Digit Code Attendant Setup – Destination Number
Define the Destination Number (up to 8 digits).
(default: No Setting)

31-05-01 Universal Night Answer/Ring Over Page
For each trunk which should ring the external page, set the External Page zone (1~9) to allow
ringing (1).
(default: 0)

81-10-07 COI Initial Data Setup – Hookflash Time Selection 1
Set the flash duration for analog trunk calls (1~255 in 16 ms steps).
Operation
Transferring Trunk Calls
To Transfer a trunk call to a co-worker's extension:
1. At the multiline terminal, press Transfer.
- OR -
At 500/2500 single line telephone, hookflash.
You hear Transfer dial tone.

2. Dial the co-worker's extension number.
If the extension is busy or does not answer, you can dial another extension number or press the line key to return

to the call. In addition, you may be able to hang up and have the call Camp-On.
SLT users can retrieve the call by pressing hookflash. If a call was transferred and the 500/2500 user has hung

up the handset, the call can be retrieved by dialing
3. Announce the call and press Transfer (PRG 15-07 or SC 751: 06) or hang up.
If you do not have Automatic On-Hook Transfer, you must press Conf (Program 15-02-24=1) or your Transfer

Programmable Function Key to Transfer the call.
If your co-worker does not want the call, press the flashing line key to return to the call.

Single line telephone users can retrieve the call by pressing hookflash. If a call has been transferred and the 500/

2500 user has hung up the handset, the call be can retrieved by dialing
had been transferred.
If you do not want to screen the call, hang up without making an announcement.

To answer a call transferred to your extension:
1. Lift the handset or press Speaker when a co-worker announces the call.
Transfer
and the extension number to which it was transferred.

and the extension number to which it

Document Revision 4C
2 - 987