NEC Electra Elite IPK II System User Manual page 1108

Document Revision 4C

84-06-01 VoIP Info – RTP Port Number
For each MG 16 ETU, enter the RTP port number (default: 10020).
Programming – Electra Elite IPK II IP Multiline Terminal or Electra Elite IPK II Multiline Terminal
with IP Adapter, Static IP Address
Setting the IP Address on an Electra Elite IPK II IP Phone or Electra Elite IPK II Multiline Terminal with IP
Adapter Using a Static IP Address
1. On the Electra Elite IPK II IP multiline terminal, enter the telephone program mode by pressing
Hold Conf .
#

This enters the IP User Menu program mode to select the settings for the individual telephone.

To enter the telephone program mode, the display must show the time, error, or Connecting message prior to

pressing Hold Conf
2. Press 1 (Network Settings).
3. Select 1 for DHCP mode. If not flashing, press 1 to disable the DHCP mode. Press the OK
softkey.
The flashing item is the current selection.

2 - 1084
#.

Figure 2-27 Selecting Network Settings Menu
Electra Elite IPK II
Voice Over Internet Protocol (VoIP)