NEC Electra Elite IPK II System User Manual page 1127

Electra Elite IPK II

40-07-01 Voice Prompt Language Assignment for VRS
Select the language to be used for the VRS. Although the system allows this option to be
changed in programming, the language changes only if the DSPII-U10 Unit has the firmware
which provides the newly selected language.
(default: 1, English)

40-08-01 Voice Prompt Language Assignment for Mailboxes
(default: 1, English)

40-10-01 Voice Announcement Service Option – VRS Fixed Message
Enable (1)/Disable (0) the system ability to play the fixed VRS messages such as "You have a
message."
(default: 0)

40-10-02 Voice Announcement Service Option – General Message Number
Enter the number of the VRS message you want to use for the General Message (01~48). The
message you select should not be used as a VRS message.
[default: 0 (No Message)]

40-10-03 Voice Announcement Service Option – VRS No Answer Destination
When all VRS ports are busy, incoming DILs and DISA calls wait for the VRS No-Answer Time
(Program 40-10-04) and then ring the VRS No Answer Destination Ring Group.

40-10-04 Voice Announcement Service Option – VRS No Answer Time
If an extension has Personal Greeting enabled and all VRS ports are busy, a DIL or DISA Call to
the extension waits for this time (0~64800 seconds) for a VRS port to become free.
(default: 0)

40-10-05 Voice Announcement Service Option – Park and Page Repeat Timer (VRS Msg Resend)
If a Park and Page is not picked up during this time (0~64800 seconds), the paging
announcement repeats.
(default: 0)

40-10-06 Voice Announcement Service Option – Set VRS Message for Private Call Refuse (VRS
Msg Private Call)
Assign the VRS Message number (0~49 )used as Private Call Refuse.
[default: 0 (No Message)]

40-10-07 Voice Announcement Service Option – Set VRS Message for Caller ID Refuse (VRS Msg
CID)
Assign the VRS Message number used as Caller ID Refuse.
[default: 0 (No Message)]

40-11-01 Preamble Message Assignment
For each trunk that should have the 900 Preamble option, enter the number of the VRS
message (0~48) that is your recorded Preamble Message.
[default: 0 (No Service)].
Voice Response System (VRS)
Document Revision 4C
2 - 1103