NEC Electra Elite IPK II System User Manual page 1109

Electra Elite IPK II
4. Access Network Settings and press 2 to enter the IP address for the telephone. The IP address
must be unique to each telephone, but the range is dependent on system programming (example:
IP Multiline Terminal 1 = 172.16.0.11, IP Multiline Terminal 2 = 172.16.0.12, etc.). The
the next set of digits (example: 172
For on-site LANs, the IP address must be unique to each telephone but the range depends on system

programming (example: IP Phone 1 = 172.16.0.11, IP Phone 2 = 172.16.0.12, etc.). When telephones are
off-site (remote LAN) , these settings depend on the remote LAN settings – not the telephone system settings.
The BK softkey backs up a character to correct an entry.

5. Access Network Settings and press 4 to enter the Default Gateway address.
For on-site LANs this is the entry in Program 10-12-03. When telephones are off-site (remote LAN) , these

settings depend on the remote LAN settings - not the telephone system settings.
6. Access Network Settings and press 4 to enter the Subnet Mask.
For on-site LANs this is the entry in Program 10-12-02. When telephones are off-site (remote LAN) , these

settings depend on the remote LAN settings – not the telephone system settings.
7. Press 3 to enter the IP telephone extension number.
8. Press 2 to enter the MGC IP address (Media Gateway Controller). Enter the IP address used in
Program 84-05-01 (default: Slot 1 – 172.16.0.20). The
172 16 0 10). Press the softkey OK.
  
The BK softkey backs up a character to correct an entry.

9. Press the SAVE softkey to save the entries and return the telephone to idle.
Pressing CANCEL instead ignores the changes made and returns the multiline terminal to idle.

Voice Over Internet Protocol (VoIP)
Figure 2-28 Selecting DHCP Mode
16 0 10). Press the OK softkey.
  
Document Revision 4C
moves to the next set of digits (example:

moves to

2 - 1085