Editing An Existing Macro - Sam4s ER-650 Operation And Program Manual

Editing an Existing Macro

ER-650/650R
4. Continue to enter keystrokes until the macro is complete. Press ESC to end the
macro recording and return to the MACRO PROGRAM screen. If you wish to
add a function to a macro that is not located on the keyboard, or if you wish to
include the CLEAR/ESC, Y/N, PAGE UP, or PAGE DOWN function to a
macro string (these keys are used for editing purposes inside this program), press
PAGE DOWN to display a keycode list:
FUNCTION
--------------------
NLU#1 - NLU#80(1-80)
ONE
TWO
THREE
FOUR
FIVE
5. With the keycode list displayed, press PAGE DOWN and PAGE UP to find the
function you wish to add to the macro. Type the numeric code number press
ENTER. The function is added to the macro.
1. After selecting a macro to program the screen displays the keystrokes currently
programmed.
1. ONE
2. TWO
3. THREE
4. FOUR
5.
6.
7.
8.
2. Press the YES/NO key to advance the cursor to the line you wish to edit.
3. With the cursor pointing at a line, press (or select) the new function you wish to
place in the macro sequence.
4. If you wish to remove a key stroke from a macro, replace the current function
with the INACTIVE function by pressing the PAGE DOWN to display a
keycode list, then enter
1 9 1.
KEYCODE
81
82
83
84
85
Program Mode Programming • 229