Macro Name - Sam4s ER-650 Operation And Program Manual

Macro Name

Up to ten function locations may be designated as Macro keys. You may wish to program a
name for a macro if the macro function appears on a function look-up key. For example if a
macro executes a series of commands to produce daily reports, you can program the
descriptor "DAILY", so the macro can easily be itentifed when it appears on the function
look up key. Macro names can also be helpful when looking at keyboard layout information
with the PC communication utility, SAM 65.
216 • Program Mode Programming
1. From the LOGO DESC. PROGRAM screen, press 5 to display the MACRO
NAME Screen:
MACRO NAME DESC. ↓
MACRO 1 :
MACRO1
MACRO 2 :
MACRO2
MACRO 3 :
MACRO3
2. Using the alpha numeric keyboard overlay, type the descriptor. You can also
program by using the descriptor code method (see page 117.) Each descriptor
can be up to 12 characters. If you make a mistake, press the BACKSPACE key
to erase the previous character. After you have completed typing the first
descriptor, press ENTER to accept the new message and advance to the TTL, or
press ESC to return to the LOGO DESC. PROGRAM screen without making
any changes.
3. Press ENTER repeatedly, or press PAGE UP and/or PAGE DOWN to locate
the next macro descriptor you wish to program. After the last item on each
screen, the screen shifts to display the next 3 macro descriptors. Using the same
procedure, continue programming each line as necessary. Press ESC at any
time to exit and return to the LOGO DESC. PROGRAM screen.
ER-650/650R