The Amount Of Center Erase; Orientation Change; Finisher; Trail Erase (Dup) - Konica Minolta bizhub 200 Service Manual

10. Tech. Rep. Mode
10.3.4

The amount of Center Erase

Functions • To set the amount of center erase for bound originals.
Use • To change the amount of center erase for bound originals.
Setting/ • The default setting is "12 mm".
Procedure • The adjustment range is 2 to 20 mm.
10.3.5

Orientation Change

• To set whether or not to match the orientation of the image when paper is fed out
Functions
between the normal mode and Staple and Punch mode.
<ON>
• Turn ON the function if the orientation of the image when paper is fed out is matched
between the normal mode and Staple and Punch mode.
Use
<OFF>
• Turn OFF the function if the orientation of the image when paper is fed out is not
matched between the normal mode and Staple and Punch mode.
• The default setting is "OFF".
Setting/
Procedure
10.3.6

Finisher

A. Punch Stop Position
Functions • To adjust the paper stop position for punching.
Use • To adjust the punch position.
Setting/ See P.32 of the FS-508/PU-501/OT-601 service manual.
Procedure
B. Punch Loop Adjustment
Functions • To adjust the length of the loop for correcting skew during punching.
Use • To correct any skew in the punch position.
Setting/ See P.33 of the FS-508/PU-501/OT-601 service manual.
Procedure
10.3.7

Trail Erase (Dup)

• To set the adjustment value for the amount of erase on the trailing edge for 2-sided
Functions
printing.
• The amount erased at the trailing edge of the second side of a 2-sided print is the Trail-
Use
ing setting for Edge Erase + Duplex Trailing Erase setting.
Setting/ • The default setting is "2 mm".
Procedure • The adjustment range is 0 to 5 mm.
158
ON "OFF"
Field Service Ver. 2.0 Apr. 2006