Chapter 2
Startup
If hooking up new gear is familiar to you, and you just want to get going, here's a quick
description of what you need to get started with your PC3K. If you need more information,
thorough descriptions of each step follow.
Make Connections
1. Set the keyboard on a hard, flat, level surface. Make sure to leave plenty of room for
2. Four adhesive‐backed rubber feet are provided with your PC3K. If you want to attach
3. Connect the power cable.
4. Make sure your sound system is at a safe volume level. Also make sure that the PC3K's
5. Plug in a pair of stereo headphones or run standard (1/4‐inch) audio cables from your
Make Music
1. Power up your PC3K, raise the level of the MASTER VOLUME slider, and check out some
2. If you hear distortion, reduce the gain on your mixing board, or use the pad if it has one.
3. Scroll through the program list with the Alpha Wheel, or the dedicated Category and
ventilation.
them to the bottom of the PC3K(recommended to prevent scratching your tabletop),
carefully turn the keyboard over, remove the paper backing from the rubber feet and
attach them now, near each corner, all on the same level.
MASTER VOLUME slider (on the far left side of the front panel) is all the way down.
amplifier or mixer to the MIX audio outputs on the PC3K. (Use the Main Left out for
mono.) Balanced ("TRS" or "Stereo") cables are recommended.
of the programs and setups. The PC3K starts up in Program mode by default. Press one of
the mode buttons to the left of the display to switch modes.
Program buttons, and try the PC3K's many sounds.
Startup
Make Connections
2-1