Table of Contents
Advertisement
Effects
The AUXFX1 and AUXFX2 Pages
If Override is set to No, the top line of the page displays the Aux 1 Chain that is loaded for the
current program, as well as the current channel. In the case of the screenshot below, the Aux 1
Chain of the current program is 906 Medium Hall2, and the current channel is 6.
Override
This parameter switches on or off the Aux override. Set Override to Yes to select an override
Aux Chain on this page. Set Override to No to allow the current program (or zone or track).
Chain
When Override is set to Yes, you can select an override Aux Chain for the page's corresponding
Aux bus. This parameter is not visible when Override is set to No.
Output
This parameter specifies the physical audio output pair for the page's corresponding Aux
Chain's output. The settings Pri. and Sec. refer, respectively, to the primary (labeled "MAIN" on
the back panel) and secondary (labeled "AUX" on the back panel) physical audio outputs of the
PC3K. Setting Output to auto uses the output pair specified in the current program (or the
program on the specified Aux Effects channel).
Mod Override
This parameter can be used to override the Mod Control source of the current program (or the
program on the specified Aux Effects channel). A setting of None yields no override in Mod
Control source, and uses the Mod Control source specified in the current program.
Send Levels and Pre/Post Ins.
There are two parameters for each of the 16 MIDI channels: Send Level (top row) and Pre‐/Post‐
Insert (bottom row). The setting for the parameter Send Level determines if the current program's
Aux Send Level is overridden, and if so, by what value. The setting for the parameter Pre‐/Post‐
Insert determines if the current program's Aux routing is overridden, and if so, by what routing.
Pre means that the Aux Send takes place before any Insert Effect is applied, whereas a setting of
Pst means that the Aux Send takes place post‐Insert Effect. (Of course, if the program on the
channel has no Insert Effects loaded, then this parameter will make no difference.) For both Send
Level and Pre‐/Post‐ Insert, a value of [p] means "no override" (i.e., use the values specified in the
program).
9-6
Advertisement
Table of Contents
