Chapter 2 Startup; Make Connections; Make Music - Kurzweil PC3LE6 Musician's Manual

Chapter 2
Startup
If hooking up new gear is familiar to you, and you just want to get going, here's a quick
description of what you need to get started with your PC3LE. If you need more information,
thorough descriptions of each step follow.

Make Connections

1. Set the keyboard on a hard, flat, level surface. Make sure to leave plenty of room for
2. Four adhesive-backed rubber feet are provided with your PC3LE. If you want to attach
3. Connect the power cable.
4. Make sure your sound system is at a safe volume level. Also make sure that the PC3LE's
5. Plug in a pair of stereo headphones or run standard (1/4-inch) audio cables from your

Make Music

1. Power up your PC3LE, raise the level of the MASTER VOLUME slider, and check out
2. Scroll through the program list with the Alpha Wheel, -/+ buttons, or use the category
ventilation.
them to the bottom of the PC3LE (recommended to prevent scratching your tabletop),
carefully turn the keyboard over, remove the paper backing from the rubber feet and
attach them now, near each corner, all on the same level.
MASTER VOLUME slider (on the far left side of the front panel) is all the way down.
amplifier or mixer to the Balanced Analog Outputs on the PC3LE. (Use the Balanced
Analog Outputs Left out for mono.) Balanced ("TRS" or "Stereo") cables are
recommended.
some of the programs. The PC3LE starts up in Program mode by default.
buttons to select programs and try the PC3LE's many sounds.
Startup
Make Connections
2-1