Control Setup; Destination; Channel; Transpose - Kurzweil PC3K Series Musician's Manual

MIDI Mode
The TRANSMIT Page
Parameter

Control Setup

Destination

Channel

Transposition
Velocity Map
Pressure Map
Program Change
Change Setups
Control Setup
This is where you select the current control setup, Zone 1 of which sets the physical controller
assignments for all programs while you're in Program mode. This parameter does not apply to
Setup mode. Refer to The Control Setup on page 7‐2 for more information on the control setup.
Destination
The Destination parameter tells the PC3K which ports will carry MIDI information, and
determines if the PC3K's sound engine will receive MIDI data. Select the desired destination or
any combination of destinations depending on your needs. For example, a value of Local
disables the USB and MIDI Out ports. Use this setting when you want to play the PC3K, but not
to send any MIDI information to other MIDI instruments (local control only.) Alternatively, you
would set this parameter to MIDI or USB_MIDI if you only wanted to send MIDI data to other
MIDI instruments from the MIDI port or USB port, and no MIDI data would be sent locally to
the PC3K's sound engine. A value of MIDI+Local would send MIDI data only to the MIDI out
port and the PC3K's sound engine.
For Setup mode, this parameter acts as a final filter for which ports will send MIDI information.
For example, if this parameter is set to MIDI_USB+MIDI, and a setup zone has its Destination
parameter set to MIDI+Local on the SetupMode:CH/PRG page, MIDI data will be sent only
through the traditional MIDI port. Both parameters, MIDI Xmit Destination and the setup
Destination parameter in the SetupMode:CH/PRG page act as filters and both are active in Setup
mode.
Note: This parameter has no effect on Song mode. In Song mode each track's destination ignores this
parameter.
Channel
This defines which MIDI channel the PC3K uses to transmit MIDI messages when not using a
setup or Song mode (each zone determines this in a setup, each track determines this in a song.)
The value for this parameter matches the current MIDI channel displayed on the top line of the
Program mode page. If you change the current MIDI channel while in Program mode, the
setting of this parameter changes accordingly, and vice versa.

Transpose

This parameter affects the transposition that's applied to the MIDI data stream. Adjusting this
parameter transposes the PC3K's notes, as well as notes on slaves receiving from the PC3K. This
transposition setting mirrors transposition settings from the Program and Setup main pages. It's
value is added to transposition settings made elsewhere. This parameter has no effect on MIDI
data sent from Song mode.
10-2
Range of Values
Setup List
USB_MIDI, MIDI, Local
1 to 16
± 60 semitones
Velocity Map List
Pressure Map List
Off, On
Immediate, KeyUp
Default
126 Internal Voices
USB_MIDI+MIDI+Local
1
0
1 Linear
1 Linear
On
Immediate